Sagem SAGEMFAST 1500WG Instalační příručka stáhnout pdf (Strana 9)

Installing the hardware 8

SAGEM F@st™ 1500 / 1500WG

Pushbutton

(4)

2.2 Powering up the modem/router

• Connect the cable (4) to the Power port located on the rear panel of the modem/router.

• Connect the power pack to a nearby socket.

• Press on the ON/Off pushbutton (holding it down).

The PWR LED comes on.

You can now connect your computers to the SAGEM F@st™ 1500/1500WG

modem/router:

• via the Ethernet interface,

see chapter 3 "Connection via the Ethernet port" ................................................. page 10

• via the wireless network interface (SAGEM F@st™ 1500WG only)

see section entitled "Configuring the wireless network" ...................................... page 17

After a few minutes, the modem/router is

automatically synchronized with your ADSL

line. The ADSL LED comes on

permanently.

If there is no synchronization, refer to the chapter "Troubleshooting"

1 - Absence of ADSL synchronization (see page 26).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 37 38

Žádné komentáře

Sagem SAGEMFAST 1500WG Instalační příručka Strana 9